+48 500 409 109

Oborniki panels and how to identify the right type

The term "płyta obornicka" is a colloquial name that does not convey the full properties of the material. When choosing, you need to establish the panel's construction and its intended use. For a small pavilion, thermal performance and appearance are not the only considerations. Moisture, cleaning, acoustics and how equipment is fixed inside also matter. Start with the core and the facings. A typical sandwich panel for building envelopes has an insulating layer bonded to two steel facings. Special variants may have a different finish on the interior side. The name alone does not determine which material has been offered.

By |2026-11-14T17:09:21+01:002025-07-27|Building academy|Comments Off on Oborniki panels and how to identify the right type
Read More

How do you find the cheapest roofing that suits a specific roof?

A low sheet price does not determine the price of the finished roof. You have to add the substrate, insulation, details and labour. The calculation for an open wood store is different from that for a heated pavilion. The most cost-effective material meets the requirements without unnecessary layers and large waste. That is why the comparison starts with function, not with a price ranking. In an open shelter, the primary task is protection and carrying the specified loads. In a heated interior, thermal performance, airtightness and moisture control are added. In a work room, acoustic comfort can also be important. Each of these objectives can change the layer build-up.

By |2026-11-14T13:14:35+01:002024-08-23|Building academy|Comments Off on How do you find the cheapest roofing that suits a specific roof?
Read More

Will mineral wool panels help reduce noise in a pavilion?

Mineral wool is often associated with quiet, but a ready-made sandwich panel has steel surfaces. Its sound insulation and its sound absorption are different properties. In a small pavilion, doors, openings and joints also determine the effect. Choosing the core alone is not enough to promise a specific level of quiet. Sound can pass through the wall, the joinery and gaps. It can also travel by flanking paths through the structure and adjacent partitions. If there is a large gate in the wall, its properties will be an important part of the result. A good panel will not automatically compensate for an open vent.

By |2026-11-14T10:56:22+01:002023-03-30|Building academy|Comments Off on Will mineral wool panels help reduce noise in a pavilion?
Read More

Choosing the material and thickness for roof insulation

Decide where the insulation will enclose the heated space and what thermal performance the complete roof needs to achieve. A rafter slope, a top-floor ceiling and a flat roof require different build-ups. In an existing building, check the timber for damp and allow space for services and finishes before comparing insulation thicknesses. An unused loft can often remain outside the heated space if the insulation runs across the ceiling below it. In that case there may be no need to insulate the slopes as well.

By |2026-11-15T04:20:52+01:002022-09-11|Building academy|Comments Off on Choosing the material and thickness for roof insulation
Read More
Back to top